RV Slideout & Leveling

RV Slideout & Leveling on the Treasure Coast

RV Slideout & Leveling on the Treasure Coast, FL. Mobile service across 16 cities. RVIA certified, 13+ years. Call 772-677-1583.

772-677-1583
Rv Slideout Leveling - Treasure Coast RV Repair

A stuck slideout turns your living room into a hallway. A failed leveling jack means a crooked rig where the fridge doesn't cool right and doors swing on their own. Florida's humidity, sand, and salt air accelerate wear on seals, motors, and hydraulic components faster than dry climates.

TL;DR

  • RV Slideout & Leveling for all RV types across the Treasure Coast
  • Pricing: $150 to $2500
  • RVIA certified, 13+ years, 4,100+ repairs
  • 12 specialized sub-services
  • Call 772-677-1583 for a free estimate

Our 12 slideout sub-services cover motor repair, seal replacement, hydraulic jacks, electric leveling, Schwintek systems, alignment, slide toppers, hydraulic pumps, manual overrides, floor repair, sensor calibration, and through-frame jacks. We work on Lippert, HWH, Power Gear, Equalizer, and Schwintek systems.

RV Slideout & Leveling We Provide

Pricing

Every job is different. Here are typical ranges for the Treasure Coast area. We always provide an exact quote before starting.

ServiceRange
Seal replacement$150 - $400
Motor replacement$300 - $700
Schwintek pair$400 - $900
Hydraulic fluid$150 - $300
Cylinder reseal$300 - $600
Leveling motor$200 - $500
Slide topper$300 - $700
Alignment$200 - $500
Full overhaul$1,000 - $2,500

Call 772-677-1583 for a free estimate on your specific situation.

Rv Slideout Leveling service on the Treasure Coast
Rv Slideout Leveling - mobile service across the Treasure Coast

RV Slideout & Leveling Questions

Why won't my slideout move?

Could be a dead motor, blown fuse, bad controller, or mechanical obstruction. Don't force it. Call us and we'll diagnose the specific cause.

How much does seal replacement cost?

$150 to $400 per slide depending on seal type and slide size. We recommend replacing all seals on a slide at once since they wear at similar rates.

My slideout leaks when it rains. Can you fix it?

Yes. Leaking slides are almost always a seal problem. We check wiper seals, bulb seals, and rain gutters and replace whatever is worn.

How often should I lubricate my slideout?

Every 3 months in Florida. Use dry silicone on seals and lithium grease on gears. We can show you the proper points during a service call.

Can you fix Schwintek in-wall slides?

Yes. Schwintek systems are one of our specialties. We replace motors, controllers, and wiring for these in-wall mechanisms.

My jacks won't retract. What's wrong?

Usually hydraulic: low fluid, air in lines, failed pump, or stuck check valve. Don't drive with jacks down. Call us.

Do you work on HWH systems?

Yes. We service HWH, Lippert, Power Gear, and Equalizer leveling systems. Each has its own quirks.

What causes slideout motors to fail?

Repeated use, water intrusion, and overloading. Florida's humidity also accelerates brush corrosion inside the motor housing.

Ready to get it fixed?

Call for a free estimate. Same-day service across the Treasure Coast.

772-677-1583